START-S3XL
Technical Manual
1
2
control unit power supply 230Vac
3
7
power supply for motor and for fl asher 230Vac
8
19
power supply voltage to accessories and to
service and safety inputs
20
21
“clean” contacts for light or photocell TEST
or fl ashing light without intermittence circuit
22
23
stop coast input + inversion for 1.5 sec
JUMPER
AC/DC
output power supply selection 24Vac
or 24Vdc on terminals 18 and 19
JUMPER
J-R
activation or deactivation of the radio receiver
DIP
1-10
function of the control unit
DIP
11-12
deceleration rate or deceleration excluded
selection
Button
P
manages wireless codes, regulates force,
increases pause time
2.1
Diagram of the control unit and electrical connections
2 Installation
Connection of the VOLTAGE line
230 Volt Single-phase alternate current.
The control unit power supply line must
always be protected with a magnetother-
mal switch or a pair of 5A fuses.
A differential switch is recommended but
not indispensable if one is already installed
on the plant.
Connection of the MOTOR
Pay particular attention not to invert
the OPEN and CLOSE poles.
When in doubt as to the correct connection, if
possible, manually position the automation at the
midpoint of its stroke. Be ready to stop the system
using the STOP control!
To be sure that the opening is really “opening”, try
to block the photocells: if the gate begins to close,
the connection is incorrect and the motor OPEN
and CLOSE wires must be inverted.
-4-
