START-S3XL
Technical Manual
-11-
4
Management of REMOTE CONTROL
To manage remote controls, the electronic circuit board must have a wireless module. The electronic circuit board
can handle several types of code, the fi rst remote control learned determines the type and, as a result, it is not
possible to learn remote controls with codes that differ from that of the fi rst remote control learned. The codes that
can be handled are the 12 to 64 bit standards and, for rolling HCS© type codes, only the fi xed part but not the rolling
counter control. The fi rst transmitter learned determines the type of code that the receiver can handle; consequently
the subsequent transmitters learned must have the same type of code.
4.1
Activation of the radio receiver
Activation of the radio receiver
433,92 Mhz
J-R
YOU CAN ACTIVATE OR DEACTIVATE THE COMPLETE ROLLING CODE FUNCTION. PRESS THE BUTTON WHEN YOU ARE
LEARNING THE PARTIAL OPENING COMMAND. THE L.E.D. WITH PARTIAL ROLLING CODE WILL FLASH
ONE TIME WHILE WHILE WHEN THE ROLLING CODE IS COMPLETE THE L.E.D. FLASHES TWICE.
1
Make certain that
DIP
switch
1
is set to
OFF
.
The automation is in the
CLOSED
position
2
>
Press the push-button
P
on the circuit board and keep it pressed for 15 seconds until
the TEST light starts fl ashing. The TEST light and the green START and PED lights go
on.The TEST light starts fl ashing
3
After 15 seconds, release push-button
P
on the circuit board.
Wait until the TEST light returns to normal fl ashing.
4.2
DELETING the codes memory
This operation deletes all codes present in the memory. There is no arrangement for deleting single codes. The
memory must be reset before learning the fi rst remote control so that there are no previously learned codes and no
unused codes in the system. The memory, and thus all the codes, can be deleted when the automation is closed.
15 secondi
ON
2
1
4
3
5
P L1
P L1
