Telpar MTP-1530II Receipt Thermal Printer User Manual
MTP-1530II User Manual (Revision 20120510)
Page 45
default to be used at power on. +n =
3 (either 03 hex or 33 hex). +m = 0
(either 00 hex or 30 hex), the printer
does not load the value from NV
memory at initialization. +m = any
value except either 00 hex or 30 hex,
the printer loads the value from NV
memory at initialization.
Frequent writes may damage the NV
memory. Maximum recommended
usage is 10 times per day.
Start/end
macro
definition
GS :
1D 3A
Macro definition starts when this
command is received during normal
operation and ends when this
command is received during macro
definition. ESC @ does not clear the
contents of the macro definition so
ESC @ can be included in the macro
definition. The contents of the macro
can not exceed 2048 bytes.
Select head
control
method
GS E +n
1D 45 +n
+n=00 hex, Print speed 1 (150
mm/second). +n=10 hex, Print speed
2 (100 mm/second). +n=20 hex, Print
speed 3 (80 mm/second). +n=30
hex, Print speed 4 (50 mm/second).
When Memory switch 8 position 1 is
set to divided energy, the maximum
speed is 120 mm/second. Default is
speed 1.
Execute
macro
GS ^ +n +m
+o
1D 5E +n +m
+o
+n (0 through 255) specifies the
number of times to execute the
macro. +m (0 through 255) specifies
how long to wait between executions
of the macro (m*100 milliseconds)
When the LSB on +o is 0, the macro
executes n times at the interval of
m*100 msec. When the LSB on +o is
1, the macro executes then after an
interval of m*100 msec the Paper
Out LED flashes and the printer
waits for the Paper Feed button to be
pressed as a signal to execute the
next sequence until the macro has
exn times
Seldom Used Commands
