Telpar MTP-1530II Receipt Thermal Printer User Manual
MTP-1530II User Manual (Revision 20120510)
Page 26
4.2 LEDs and Error Indication
Three LEDs (LED1, LED2, and LED 3) are located below the cutout in
the side chassis (above the DIPSWITCH and next to the on-board paper
feed switch) as shown in the picture and figure below.
LED 1 POWER LED
: ON means power is stable and the printer is ready
for operation. OFF means power in not stable.
LED 2
is a
PAPER OUT LED
, OFF means paper is installed and the
printer is ready for operation. ON means there is no paper
installed in the printer mechanism (or the paper low sensor if
selected). The PAPER OUT LED blinks steadily to specify that
self test has finished the first part of printing and that the user
can press the PAPER FEED button to print the “barber pole”
character print part of the self test. The PAPER OUT LED also
blinks steadily to specify that a MACRO is waiting for the user to
press the PAPER FEED button to continue it’s execution (macro
stand-by mode).
LED 3
is an
ERROR LED
. OFF means there are no errors and the
printer is ready for operation. ON indicates the printer is OFF
LINE (except during paper feeding using the FEED button, during
self-test printing, and in the error state). The ERROR LED blinks
a defined pattern every 5.12 seconds to notify the user of various
error conditions. When the LED is normally OFF and blinks ON,
an error is indicated which may be recoverable. . When the LED
is normally ON and blinks OFF, an error is indicated which in not
recoverable. For any error that is not recoverable, power should
be turned off as soon as possible.
Location of
LED 1, LED2,
and LED 3
Board Mounted
Paper Feed Switch
LED 3 (Error)
LED2 (paper out)
LED1 (power)
On-Board
Paper Feed
Switch
DIPSWITCH
