Telpar MTP-1530II Receipt Thermal Printer User Manual
MTP-1530II User Manual (Revision 20120510)
Page 39
Select
standard
mode
ESC S
1B 53
Data buffered in page mode is
cleared. The printing area set by
ESC W is initialized. Settings of ESC
SP, ESC 2, ESC 3 are switched to
the standard mode values. See FF,
ESC FF, ESC L.
Select print
direction
ESC T +n
1B 54 +n
Sets the position where data is
buffered within the printing area set
by ESC W. n=0 (either 00 hex or 30
hex) sets the starting position to the
upper left corner and printing goes
from left to right. n=1 (either 01 hex
or 31 hex) sets the starting position
to the lower left corner and printing
goes from bottom to top. n=2 (either
02 hex or 32 hex) sets the starting
position to the lower right corner and
printing goes from right to left. n=3
(either 03 hex or 33 hex) sets the
starting position to the upper right
corner and printing goes from top to
bottom.
In page
mode, set
printing area
ESC W +x1
+x2 +y1 +y2
+dx1 +dx2
+dy1 +dy2
1B 57 +x1
+x2 +y1 +y2
+dx1 +dx2
+dy1 +dy2
x1+x2*256 = horizontal starting
position. y1+y2*256 = vertical
starting position. dx1+dx2*256 =
printing area width. dy1+dy2*256 =
printing area height Defaults are
x1=x2=y1=y2=0, dx1=128 for 82.5
mm printer or 64 for 80 mm printer,
dx2=2, dy1=152 for 82.5 mm printer
or 226 for 80 mm printer, dy2=2.
Set relative
print position
ESC \ +n +m
1B 5C +n +m
Set printing position to current
position plus (n+m*256)*0.125 mm.
If the starting position is set (by ESC
T) to the upper left or lower right of
the printing area then the offset is in
the horizontal direction but if the
starting position is set to the upper
right or lower left of the printing area
then the offset is in the vertical
direction.
Page mode,
Set absolute
vertical print
position
GS $ +n +m
1D 24 +n +m
Sets the absolute vertical starting
position to buffer character data to
(n+m*256)*0.125 mm referenced to
the starting
posotopn
defined by ESC
T. If the starting position is set (by
ESC T) to the upper left or lower
right of the printing area then the
position is in the vertical direction but
if the starting position is set to the
upper right or lower left of the
printing area then the position is in
the horizontal direction.
Page mode,
set relative
vertical print
position
GS \ +n +m
1D 5C +n +m
Set printing position to current
position plus (n+m*256)*0.125 mm
positive (down the page) or 65536-
(n+m*256)*0.125 mm negative (up
the page). If the starting position is
set (by ESC T) to the upper left or
lower right of the printing area then
the offset is in the vertical direction
