Telpar MTP-1530II Receipt Thermal Printer User Manual
MTP-1530II User Manual (Revision 20120510)
Page 68
Notes pertaining to Ethernet Settings:
Changing internal parameter settings:
Internal parameter settings can be changed with the following methods:
•
ENPC protocol
•
HTTP browser
•
arp and ping commands (Only IP address is settable.)
Setting with a dedicated utility:
Epson provides a dedicated utility that makes miscellaneous settings with the ENPC protocol.
Setting with a browser:
An HTTP browser can make setting when connected to the module. The new IP address takes effect
when the printer power is turned off and back on.
Setting the IP Address with arp + ping:
This function is available only when it has been enabled. The setting can be made only from a
host PC that supports both arp and ping commands and is in the same segment as the module.
The new IP address takes effect when the BA-T500
II
E responds to the ping command.
Example1
: When using Sun OS
arp –s 123.456.789.123 00:00:85:06:00:01 temp
ping 123.456.789.123
Example2
: When using Windows OS
arp –s 123.456.789.123 00-00-85-06-00-01
ping 123.456.789.123
How to check the Mac Address:
The Mac address of the BA-T500
II
E can be confirmed with the following methods:
•
Printing the status sheet
•
Label attached to the BA-T500
II
E
•
Using HTTP browser
•
Printer self-test
Start up period:
To initialize the BA-T500
II
E and network connection, there is start up period after the power of
printer is turned on or reset. The start up period depends on the IP address setting as follows:
When setting IP address manually: approximately 6 seconds
When setting IP address automatically: approximately 13 seconds (It may take some more time,
depending on the DHCP server response time.)
During this period, no network function works.
Setting the TM printer:
A Start up period is required after turning the printer power on (as described above).
To run a printer self-test, hold the FEED button down during this period.