TELNET GPONDoctor 9500, User Manual

Page: 58 / 105

GPONDoctor 9500
User manual
200080279-00 GPON DOCTOR 9500 user manual EN v0 WEB
58

Assigned ONT-ID on Assign ONT-ID PLOAM message is equal or greater to 254.

Upstream deprecated options: SN-Mask, or retransmission.

POPup message received in O5 state

High BER reported on upstream PLOAM message by ONT

PLOAM messages sent to/by ONT: Doesn’t match supposed XGTC state of the
ONT.

PEE (Physical Equipment Error) reported by ONT. ONT can’t send OMCC or XGEM
messages

ONT reporting “Urgent Upstream PLOAM message waiting to be sent” and OLT
didn’t allow the ONT to send PLOAM messages for more than 5ms

ONT enters in LOSi or LOFi

ONT enters POPUP State

ONT Enters in Emergency Stop State due to an OLT message.

OLT reporting PEE (Physical Equipment Error): OLT can’t send OMCC or GEM
messages

Dying GASP message received from “dying” ONT
3.5.3
Starting and Stopping the Analysis
Once the start/stop analysis time has been configured and the desired “Issue detection”
options selected, to start the analysis process, click on Start Analysis.
A progress window will appear until analysis is finished. Analysis can be stopped at any
time, by clicking on “Cancel”. However, results are not guaranteed to be coherent if the
process is stopped by the user. As shown below.
Figure 29 Analysis wait window allowing to cancel analysis process.