11
2.4.6 Speed dialing
Speed dialing of the 1-4 phone numbers can be initiated by pressing the appropriate
1-4 key for at least 3 seconds. Key 1 stands for the first phone number, key 2 for the
second, key 3 for the third and key 4 for the forth phone number.
The call is initiated automatically in hands-free mode. The call in progress can be ended
by pressing Cancel
key. If the called number is not available, is busy, or there is no
phone number stored in the given memory section, the device indicates this by playing
“
Unsuccessful call
” voice message.
2.4.7 Assigning the RF transmitter
The device supports usage of two RF transmitters. If you assign the RF transmitter to
the device, emergency call can be started with the assigned transmitter only. If no RF
transmitters are assigned to the device, it will work with any easyAID RF transmitter,
any easyAID RF transmitter can start emergency calls.
Steps of assigning a transmitter:
1) Press the Settings
key continuously for at least 5 seconds, then “
PASS
”
is displayed on the digital display
2) Enter the user password using the 1-4 function keys (the password is: 1111).
The digital display shows “
ok
”, then “- - - -”.
3) Keep the Cancel
key pressed and press once function key 1 or 2,
according to the number of the memory slot you wish to assign the given RF
transmitter to. The digital display will show the number of the selected memory
slot (“
1
” or “
2
”).
4) Press the button of the RF transmitter you wish to assign. If assigning was
successful, “
ok
” will be displayed on the digital display, then after emitting a
signal tone the module will exit the programming mode automatically. To
assign a new RF transmitter, repeat the above steps by selecting this time the
memory slot which is not in use yet.
2.4.8 Erasing all RF transmitters
If no RF transmitters are assigned to the device, or if you erase all RF transmitters, the
device will work with any easyAID RF transmitter, any easyAID RF transmitter can start
emergency calls.
Steps of erasing all transmitters:
1) Press the Settings
key continuously for at least 5 seconds, then “
PASS
”
is displayed on the digital display
2) Enter the user password using the 1-4 function keys (the password is: 1111).
The digital display shows “
ok
”, then “- - - -”.
3) Keep the Cancel
key pressed and press once function key 3. “
Er
” will be
displayed on the digital display, then after emitting a signal tone the module will
exit the programming mode automatically.
