Telit Wireless Solutions UC864-E, Reference Manual

Page: 55 / 329

UC864 UC864 UC864 UC864----E/G/WD/WDU E/G/WD/WDU E/G/WD/WDU E/G/WD/WDU AT Commands Reference Guide AT Commands Reference Guide AT Commands Reference Guide AT Commands Reference Guide
80304ST10041a Rev. 6 80304ST10041a Rev. 6 80304ST10041a Rev. 6 80304ST10041a Rev. 6 ---- 2010 2010 2010 2010----0 00 05 55 5----20 20 20 20
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 55 of 329
3.5.3.2.4. Extended Result Codes Extended Result Codes Extended Result Codes Extended Result Codes ---- X X X X
X
X X
X ---- Extended Result Codes
Extended Result Codes Extended Result Codes
Extended Result Codes
ATX[<n>] ATX[<n>] ATX[<n>] ATX[<n>]
Set command selects the result code messages subset used by the modem
to inform the DTE
DTE DTE
DTE of the result of the commands.
Parameter:
<n>
<n> <n> <n>
0 - send only OK
OK OK
OK, CONNECT
CONNECT CONNECT
CONNECT, RING
RING RING
RING, NO CAR
NO CAR NO CAR
NO CARRIER
RIER RIER
RIER, ERROR
ERROR ERROR
ERROR, NO ANSWER
NO ANSWER NO ANSWER
NO ANSWER
results. Busy tones reporting is disabled.
1..4 - reports all messages (factory default is 1).
Note: If parameter is omitted, the command has the same behaviour of
ATX0
ATX0 ATX0 ATX0
Note: Current value is returned by AT&V
Parameter:
<n>
0 - EXTENDED MESSAGES : X0=NO
1..4 - EXTENDED MESSAGES : X1=YES
Note For complete control on CONNECT
CONNECT CONNECT
CONNECT response message see also +DR
+DR +DR
+DR
command.
Reference V25ter
3.5.3.2.5. Identification Information Identification Information Identification Information Identification Information ---- I I I I
I
I I
I ---- Identification Information
Identification Information Identification Information
Identification Information
ATI[<n ATI[<n ATI[<n ATI[<n>] >] >] >] Execution command returns one or more lines of information text followed
by a result code.
Parameter:
<n>
<n> <n> <n>
0 - numerical identifier.
1 - module checksum
2 - checksum check result
3 - manufacturer
4 - product name
5 - DOB version
Note: if parameter is omitted, the command has the same behaviour of
ATI0
ATI0 ATI0
ATI0
Reference V25ter