UC864
UC864
UC864
UC864----E/G/WD/WDU
E/G/WD/WDU
E/G/WD/WDU
E/G/WD/WDU AT Commands Reference Guide
AT Commands Reference Guide
AT Commands Reference Guide
AT Commands Reference Guide
80304ST10041a Rev. 6
80304ST10041a Rev. 6
80304ST10041a Rev. 6
80304ST10041a Rev. 6 ---- 2010
2010
2010
2010----0
00
05
55
5----20
20
20
20
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved.
Page 82 of 329
3.5.4.2.5.
Service Reporting Control
Service Reporting Control
Service Reporting Control
Service Reporting Control ---- +CR
+CR
+CR
+CR
+CR
+CR
+CR
+CR ---- Service Reporting Control
Service Reporting Control
Service Reporting Control
Service Reporting Control
AT+CR=[<mode>]
AT+CR=[<mode>]
AT+CR=[<mode>]
AT+CR=[<mode>]
Set command controls whether or not intermediate result code +CR
+CR
+CR
+CR is
returned from TA
TA
TA
TA to TE
TE
TE
TE.
Parameter:
<mode>
<mode>
<mode>
<mode>
0 - diCR
+CR
+CR
+CR reporting (factory default)
1 - eCR
+CR
+CR
+CR reporting: the intermediate result code is transmitted at
the point during connect negotiation at which the TA
TA
TA
TA has determined
which speed and quality of service will be used, before any error control
or data compression reports are transmitted, and before the
intermediate result code CONNECT
CONNECT
CONNECT
CONNECT is transmitted. Its format is:
+CR: <serv>
+CR: <serv>
+CR: <serv>
+CR: <serv>
where:
<serv>
<serv>
<serv>
<serv>
ASYNC - asynchronous transparent
SYNC - synchronous transparent
REL ASYNC - asynchronous non-transparent
REL SYNC - synchronous non-transparent.
Note: this command replaces V.25ter [14] command Modulation Reporting
Control (+MR
+MR
+MR
+MR), which is not appropriate for use with a UMTS terminal.
AT+CR?
AT+CR?
AT+CR?
AT+CR?
Read command returns whether or not intermediate result code +CR
+CR
+CR
+CR is
enabled, in the format:
+CR: <mode>
+CR: <mode>
+CR: <mode>
+CR: <mode>
AT+CR=?
AT+CR=?
AT+CR=?
AT+CR=?
Test command returns the supported range of values of parameter
<mode>
<mode>
<mode>
<mode>.
Reference
3GPP TS 27.007
3.5.4.2.6.
Extended Error Report
Extended Error Report
Extended Error Report
Extended Error Report ---- +CEER
+CEER
+CEER
+CEER
+CEER
+CEER
+CEER
+CEER ---- Extended Error Report
Extended Error Report
Extended Error Report
Extended Error Report
AT+CEER
AT+CEER
AT+CEER
AT+CEER
Execution command returns one or more lines of information text <report>
<report>
<report>
<report>
offering the TA user an extended error report, in the format:
+CEER:
+CEER:
+CEER:
+CEER: <report>
<report>
<report>
<report>
This report regards some error condition that may occur:
