GE/GC864-QUAD V2 and GE864-GPS Hardware User Guide
1vv0300915 Rev.5 – 2011-10-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved.
Page 78 of 94
13.2.
ADC Converter
13.2.1.
Description
Ball
GE864
Pin
GC864
Signal
I/O
Function
ADC Converters
J11
37
ADC_IN1
AI Analog/Digital converter input
H11
38
ADC_IN2
AI Analog/Digital converter input
N/A*
39
ADC_IN3
AI Analog/Digital converter input
The GE/GC864-QUAD V2 AND GE864-GPSmodules provide three* (only two in GE864-
QUAD V2) Analog to Digital Converter.
The on board A/D are 11-bit converter. They are able to read a voltage level in the range of
0÷2 volts applied on the ADC pin input, store and convert it into 11 bit word.
Min
Max
Units
Input Voltage range
0
2
Volt
AD conversion
-
11
bits
Resolution
-
< 1
mV
13.2.2.
Using ADC Converter
The AT command below is available to use the ADC function:
AT#ADC=1,2
The read value is expressed in mV.
Refer to SW User Guide or AT Commands Reference Guide for the full description of this
function.
