![background image](http://html1.mh-extra.com/html/telit-wireless-solutions/gc864-quad-v2/gc864-quad-v2_hardware-users-manual_1083640019.webp)
GE/GC864-QUAD V2 and GE864-GPS Hardware User Guide
1vv0300915 Rev.5 – 2011-10-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved.
Page 19 of 94
NOTE:
If not used, pins must be left disconnected,
with the exceptions listed in the table below
:
(2) Available only on GE864-GPS (in case of GE864-QUAD V2 it has to be considered
RESERVED)
NOTE:
Only for GE864-GPS,
do not leave
the GPS_ON_OFF (ball J4) input pin floating. It’s
suggested to connect them to a pull-down (e.g.: 100k).
Ball
Signal
Function
J1, J2, K1, K2
VBATT
Main power supply
A1, A8
(2)
, A11, B8
(2)
, B9
(2)
, B10
(2)
,
B11
(2)
, D6, F1, F11, H1, H2, J3, K3,
K4, K5, K6, L1, L2, L3, L6, L11
GND
Ground
E7
C103/TXD
Serial data input (TXD) from DTE
H8
C104/RXD
Serial data output to DTE
F7
C105/RTS
Input for Request to send signal (RTS) from DTE
J5
ON/OFF#
Input command for switching power ON or OFF (toggle command).
A2
RESET#
Reset input
F10
RX_TRACE
RX Data for debug monitor
D11
TX_TRACE
TX Data for debug monitor
H4
SERVICE
SERVICE connection
B7
DTR
Input for Data terminal ready signal (DTR) from DTE
J4
(2)
GPS_ON_OFF
GPS Power Control
G2
(2)
GPS_WAKEUP
GPS Wake up output
E10
(2)
GPS_RX
GPS Serial data input
F8
(2)
GPS_TX
GPS Serial data output
C6
(2)
-
Diagnostic
G6
(2)
-
Diagnostic