Model TGFX-HUB1
© 2018 Telguard
24
REBUILD THE NETWORK
If adding or removing a device does not complete, verify the device is in range of the FlexHub and
retry.
Remember to always select Rebuild Network when all your Z-Wave devices have been installed in
their final location. If you have added a Z-Wave controller to your network, select the Replicate option
to initiate network replication.
Like a chain, your Z-Wave mesh network is only as strong as the weakest link. Following the Rebuild
Network process, or if your network reports an Orphaned Device, you may need to add additional
non-powered Z-Wave nodes to create a more robust network.
INCLUDING THE FLEXHUB IN AN EXISTING Z-WAVE NETWORK
If you already have a Z-Wave controller and would like to add the FlexHub to an existing Z-Wave
network, you will need to refer to your controller’s documentation to determine how to activate
“Inclusion Mode.” Once your existing controller is in “Inclusion Mode,” you may add the FlexHub by
selecting the right arrow next to FlexHub Devices and then tapping the Op Learn Command button.
Once the FlexHub is added to the existing network, it can take several minutes for the network
devices to show up in the HomeControl Flex mobile app. When they do, you may use the app to
control network devices as if they were on the FlexHub network.
EXCLUDING THE FLEXHUB FROM AN EXISTING Z-WAVE NETWORK
To remove the FlexHub from another controller’s network, place the other controller into device
exclusion mode. Refer to your controller’s documentation to determine how to activate “Exclusion
Mode.” Once your existing controller is in “Exclusion Mode,” you may remove the FlexHub by
selecting the right arrow next to FlexHub Devices and then tapping the Op Learn Command button.
Summary of Contents for FlexHub TGFX-HUB1
Page 1: ...FlexHub Installation Guide Model TGFX HUB1 ...
Page 29: ......
