Model TGFX-HUB1
© 2018 Telguard
18
because many devices do not use a physical button to start the exclude process.
Once the orphan device is removed, the Z-Wave light will stop flashing. If an orphan device is not
found, the exclusion mode will end after 1 minute.
REBUILD THE NETWORK
If adding or removing a device does not complete, verify the device is in range of the FlexHub and
retry.
Remember to always select Rebuild Network when all your Z-Wave devices have been installed in
their final location. If you have added a Z-Wave controller to your network, select the Replicate option
to initiate network replication.
Like a chain, your Z-Wave mesh network is only as strong as the weakest link. Following the Rebuild
Network process, or if your network reports an Orphaned Device, you may need to add additional
non-powered Z-Wave nodes to create a more robust network.
ADDING CAMERAS
To add an Arlo Wire-Free Video system to your
HomeControl Flex site, select the Devices tab.
Go to the Cameras selection and select the Add
button.
Enter the Arlo Username and Password and
click Sign In.
Click Accept to allow HomeControl Flex to
access the Arlo system data.
Summary of Contents for FlexHub TGFX-HUB1
Page 1: ...FlexHub Installation Guide Model TGFX HUB1 ...
Page 29: ......
