Teletype 43 Teleprinter Basic RO, Service Manual

Page: 81 / 222

CONTROLLER CIRCUIT CARDS (Pedestal Based)
3.12
To remove circuit cards from the controller:
0
Lift out back
panel.
card extractors.
0
Remove circuit
card.
MANUAL 406, 1-71
CIRCUIT CARD
EXTRACTOR
Note: In replacing circuit card be sure card is in guide slot and push in equally on top and bottom of
circuit card. Make sure card is fully seated.
CONTROLLER(Pedestal Based)
3.13 To remove the controller from the pedestal:
G)
Remove back panel.
Perform 3.12 Steps 1 and 2.
0
Unplug cable from
::
power
Disconnect ground
strap from controller.
PEDESTAL
POWER CORD
Note 1: In reassembly make sure tabs on controller are seated in slots in pedestal floor.
Note 2:
If a new controller is being installed, the eight 124516 grommets supplied with the controller
should be placed on the controller feet before assembling the controller to the pedestal.