Teletype 43 Teleprinter Basic RO, Service Manual

Page: 128 / 222

406,2-38
E. (Cont)
3. (Cont)
COLLAR WITH LINK
3.11 To remove the collar with link:
CD
Remove operator console, if present.
See Page 1-62.
0
Remove print head and carriage
(perform
3.01 and 3.09).
0
Remove compression
ring.
-----_,
PAPER TRAY
3.12
To remove the paper tray:
(a) Sprocket Feed, Early ArraDgement
Note 1: Parts on left and right sides are similar.
CD
Remove two 119653 retaining
rings from paper tray shaft.
PRY
POINTS
(D
Push locking handle to the left
and rotate locking handle and
collar fully counterclockwise
(forward). Pull the handle to
the right while slowly rotating
handle and collar clockwise
(rearward) until key on handle
aligns with slot in carriage.
Locking handle will pop out.
Remove paper tray.
0
Pull paper tray shaft out to right.
PAPER
GUIDE
Unhook and retain two
4
708
paper tray springs (one each
side).
Lift left and right paper guides to up position,
loosen mounting screws friction tight, and
position paper guide bracket toward the frame
by using a screwdriver on the pry points.
Note 2: In reassembly, LEFT AND RIGHT PAPER GUIDE adjustments must be made
(Early Arrangement).