Teletype 43 Teleprinter Basic RO, Service Manual

Page: 20 / 222

406, 1-10
B. INSTALLATION AND REMOVAL (Cont)
3.
INSTALLATION PROCEDURE
(Pedestal Based) (Cont)
B. Assembly
(Perform steps
3.08
through
3.10
if not assem­
bled.)
3.08
Fasten the KP set to the pedestal using
the four clips provided. Place KP set on
top of pedestal, lining up grooves on bottom of
housing with slots in pedestal and tray. Push in
each slip until fully seated. See Fig.
3.
/<'::/
/
430331
l
(2- Plastic)
PEDESTAL
Fig.
3
3.09
Connect the ground strap, attached to the
KP, to the pedestal
as
shown in Fig.
4.
3.10
Connect the SSI cable plug (extending
1.5
feet from the upper r�ar of the
pedestal) to the KP SSI port located at left rear
of the bustle. Turn off KP set power switch by
depressing lower half. (See Fig.
4.)
3.11
With
ac
power to the customer supplied
data set turned off, connect the data set
cable (extending
5
feet from the lower rear of the
pedestal, see Fig.
4)
to the data set. See page 1-11
for EIA interface leads and descriptions. Secure
using
2 captive screws on plug. For distances
greater than
5
feet to the data set, the existing
data set cable can be extended by use of the fol­
lowing shielded EIA cables available from Tele­
type Corporation:
7
Feet Length
12
Feet Le<tgth
25
Feet Length
50
Feet Length
KD SET
POWER
CORD
DATA SET CABLE
(EIA-Shielded
25-Pin Plug)
Fig.
4
408065
408066
408067
408068
KP
SSI PORT
(9·Pin Receptacle)
SSI CABLE