Teletype 43 Teleprinter Basic RO, Service Manual, Page: 22 / 222

406,1-12
B. INSTALLATION AND REMOVAL (Cont)
3. INSTALLATION
(Pedestal Based) (Cont)
3.12 Position the terminal in the location
specified by the customer. A minimum of
6 inches of space behind the terminal
is
required
when the paper holder (sprocket or friction)
is
used to feed the paper and
9
inches of space is
required when sprocket feed paper is fed from a
box behind the terminal on the floor. Additional
space is required if paper with folded form lengths
greater than
8-1/2 inches is used. The ac power
cords for the KP set and for the pedestal extend
6 feet to the rear.
3.13
Stabilize the terminal by adjusting the left
or right pedestal leg leveling screw. See
Fig.
5.
�----­
"
'
'
., ,
,. .... -I.�
-�"'t'f .. -----
Fig.
5
REAR
BUSTLE
LEVELING
SCREW
3.14
Assemble the paper holder or paper supply
assembly as shown in Fig. 6.
(a) Sprocket Feed: Attach the paper holder
to the bustle cover by hooking in the end
slots (early design) or sliding down over the
bushings (late design).
(b) Friction Feed: Pull the latches straight
up and slide the paper supply assembly
fully onto the mounting posts located at the
rear of the bustle cover. Push down on the
latches until they are secured over the mounting
posts.
I
I
Fig. 6
PAPER HOLDER
(Sprocket Feed
Late Design)
PAPER HOLDER
(Sprocket Feed
Early Design)