PRISM MPX2-DUALDSP Installation and Safety Instructions
1
Installation
Initial product inspection
Perform the product inspection procedure when you receive your Dual Display module:
1.
Inspect the shipping carton for external damage, which may indicate damage to the module.
2.
Remove the PRISM Dual Display module from the shipping carton, and then check that the module has not been
damaged in transit. Prior to shipment the module is thoroughly inspected for mechanical defects. The exterior should
not have any scratches or impact marks.
NOTE.
Save the shipping carton and packaging materials for module repackaging in case shipment becomes necessary.
3.
Verify that the shipping carton contains the module, the standard accessories, and any optional accessories that you
ordered. (See
Exterior cleaning
The module exterior was inspected for debris when it was shipped. If necessary, you can clean the exterior of the
module.
WARNING.
To prevent injury or death, power off the module and disconnect it from line voltage before cleaning.
Clean the exterior surfaces of the chassis with a dry lint-free cloth or a soft-bristle brush. If any dirt remains, use a cloth or
swab dipped in a 75% isopropyl alcohol solution. Use a swab to clean narrow spaces around controls and connectors. Do
not use abrasive compounds on any part of the module that may be damaged by it.
CAUTION.
Avoid the use of chemical cleaning agents that might damage the plastics used in the module. Use a 75%
isopropyl alcohol solution as a cleaner and rinse with deionized water. Before using any other type of cleaner, consult
your Telestream Service Center or representative.
