Further Settings
Page 36
2004 by TELES AG Berlin, Version 2.0/iPBX8TRe/6.02, Issue: May 1998
5.2 ISDN Port Configuration
The TELES.iPBX 8TR Box is suited for point-to-multipoint line (also known as
S/T interface) as well as for point-to-point line.
The factory setting is point-to-multipoint line because this ISDN interface type
is most common in private homes and home-offices. In this case, no changes are
necessary.
5.2.1 Reset to Point-to-Point Line
Υ
Lift the receiver. You hear the dial tone.
∗
Press the star key.
Π
Enter the PIN if necessary.
080
Enter the digits 080. The TELES.iPBX 8TR Box is reset from
point-to-multipoint to point-to-point line.
#
Press the pound key.
∆
Listen for the confirmation tone. Put the receiver down.
A running light through all LEDs shows that the box is configur-
ing for point-to-point line. When only the red LED is lit the box
is ready for operation. Should problems with the outside line ac-
cess arise, briefly interrupt the power supply.
5.2.2 Reset to Point-to-Multipoint Line
Υ
Lift the receiver. You hear the dial tone.
∗
Press the star key.
Π
Enter the PIN if necessary.
081
Enter the digits 081. The TELES.iPBX 8TR Box is reset from
point-to-point to point-to-multipoint line.
#
Press the pound key.
∆
Listen for the confirmation tone. Put the receiver down.
A running light through all LEDs shows that the box is configur-
ing for point-to-multipoint line. When only the red LED is lit the
box is ready for operation. Should problems with the outside line
access arise, briefly interrupt the power supply.
