Blocks
2004 by TELES AG Berlin, Version 2.0/iPBX8TRe/6.02, Issue: May 1998
Page 31
4.7.3 Assign Blocked Numbers
The blocks 7 and 8 are not configured. They can be assigned to your choice of
digits. In opposition to blocks 1 through 6, they cannot be activated as precon-
figured blocks. You have to enter the number to be blocked every time you re-
new the block.
Υ
Lift the receiver. You hear the dial tone.
∗
Press the star key.
Π
Enter the PIN if necessary.
1
Enter the digit 1.
Ν
Select the type of block, either 7 or 8.
Ν
Select the port for which the block should be activated.
Ν
Enter the number that you would like to block for the appropri-
ate port.
#
Press the pound key. Listen for the confirmation tone.
Example:
Set block 7 for port 3. The block contains the prefix 0033 in-
cluding outside line access.
∗
(
Π
)
1
7
3
00033
#
Note:
When you have set a freely configured block for two ports and
then change the blocked call number at one port, the change is
valid for the other port as well.
