Teledyne TIENet 310 Ex, Installation And Operation Manual

Page: 19 / 42

TIENet® Model 310 Ex Ultrasonic Level Sensor
Section 2 Installation and Setup for Signature
2-5
6. Gently tug the cable downward, to remove any slack within
the enclosure, taking care not to put any stress on the con-
nection.
7. Tighten the cord grip sealing nut.
CAUTION
If you are using conduit instead of the cord-grip fitting, the con-
duit must be sealed to prevent harmful gases and moisture
from entering the Signature enclosure. Failure to seal conduit
could reduce equipment life.
8. Close the front panel and fasten it shut with the two Phil-
lips screws.
Figure 2-5 Position and secure the cable
2.2.2 Connecting to
Signature Portable via
a TIENet Receptacle
The optional external TIENet devices compatible with the Sig-
nature Portable (and Signature) all scan into the hardware in the
same manner. A scan is required anytime a new TIENet device is
added.
Multiple TIENet devices can be connected simultaneously to the
same Signature Portable Flow Meter. The following TIENet
devices will attach to the TIENet receptacle:
• Ultrasonic Level Sensor