Teledyne Princeton Instruments NIRvana HS, System Manual

Page: 19 / 107

Chapter 2 NIRvana HS Camera System 19
2.1.4 Rear-Panel Connectors
Figure 2-3 illustrates the rear-panel connectors on a NIRvana HS camera.
Figure 2-3: NIRvana HS Rear-Panel Connectors
Refer to Table 2-1 for information about each rear-panel connector.
Table 2-1: NIRvana HS Rear-Panel Connectors (Sheet 1 of 2)
Label Description
POWER Green LED. When illuminated, indicates that the NIRvana HS is powered on.
DC IN 12 V
DC
(11.5 A max) input and TEC control from power supply.
FAULT This Red LED is normally extinguished.
When illuminated or flashing, this LED indicates a fault within the system has
been detected. Refer to
Appendix E, Troubleshooting , on page 93 for additional
information.
TRIGGER IN 0 to +5.0 V
DC
TTL-compatible logic level input with a 10 k

pull-up resistor.
Allows data acquisition and readout to be synchronized with external events.
Positive or negative edge triggering is programmable.
CAUTION: Do not apply a voltage greater than +5.0 V
DC
to this input. Doing
so may permanently damage the NIRvana HS camera.
441
1-0
16
9
_
0
00
3