Piranha4 8K Color Camera User's Manual
29
Teledyne DALSA
03-032-20156-02
!
Power Connector
WARN IN G:
It is extrem ely im p ortant that you ap p ly the ap p rop riate voltages to you r cam era.
Incorrect voltages m ay d am age the cam era. Inp u t voltage requ irem ent: +12 VDC to +24 VDC,
2 Am p s. Before connecting p ow er to t he cam era, test all p ow er su p p lies.
Figure 12: 6-pin Hirose Circular Male Power Plug—Power Connector
Table 5. Power Plug Pinout
Pin
Description
Pin
Description
1
+12 V to +24 V DC
4
GN D
2
+12 V to +24 V DC
5
GN D
3
+12 V to +24 V DC
6
GN D
The cam era requ ires a single voltage inp u t +12 VDC to +24 VDC. The cam era m eets all p erform ance
sp ecifications u sing stand ard sw itching p ow er su p p lies, althou gh w ell-regu lated linear su p p lies p rovid e
op tim u m p erform ance.
WARNING: When setting up the camera’s power supplies follow these guidelines:
Ap p ly the ap p rop riate voltages.
Protect the cam era w ith a 2 am p slow -blow fu se betw een the p ow er su p p ly and the cam era.
Do not u se the shield on a m u lti-cond u ctor cable for grou nd .
Keep lead s as short as p ossible in ord er to red u ce voltage d rop .
Use high-qu ality su p p lies in ord er to m inim ize noise.
Note:
If you r p ow er su p p ly d oes not m eet these requ irem ents, then the cam era p erform ance sp ecifications
are not gu aranteed .
LEDs
The cam era is equ ip p ed w ith an LED on the back to d isp lay the op erational statu s of the cam era. The
table below su m m arizes the op erating states of the cam era and the corresp ond ing LED states. When m ore
than one cond ition is active, the LED ind icates the cond ition w ith the highest p riority.
Color of Status LED
Meaning
Off
N o p ow er, or hard w are m alfu nction .
Dark Blu e
In boot-load er. Com p leting firm w are u p grad e.
Light Blu e
Bu sy. For exam p le, p ow ering u p or p erform ing a calibration.
Green
Read y.
Red
Error. Check BiST register, in the list of
, for the
sp ecific error.
!
