Falcon4 86M Cameras
Contents
51
I /
O Control Category
The camera‘s I / O controls, as shown by CamExpert, group features used to configure external
inputs and acquisition actions based on those inputs, plus camera output signals to other devices.
I/O Controls Feature Descriptions
The following table describes these parameters along with their view attribute.
Display Name
Feature & Values
Description
Standar
d
& View
Trigger Selector
TriggerSelector
Displays the type of trigger to configure with the
various Trigger features. <RO>
Beginner
FrameStart
FrameStart
Selects a trigger starting the capture of a single frame.
Trigger Mode
TriggerMode
Enables and disables external frame trigger.(RW)
Beginner
Off
Off
Use an internal trigger.
On
On
Use an external trigger. This option is not available
while in Calibration Mode.
Trigger Source
TriggerSource
Specifies the internal signal or input line to use as the
trigger source. (RW)
The trigger mode must be set to On.
Beginner
Software
Software
Software trigger through the TriggerSoftware
command.
LinkTrigger0
LinkTrigger0
CLHS trigger message from the FG.
Line1
Line1
General Purpose Input Line 1
Line2
Line2
General Purpose Input Line 2
Software Trigger
TriggerSoftware
Generate an internal trigger. Available when the
trigger mode is enabled and the trigger source is
equal to Software.(W)
Beginner
Trigger Delay
TriggerDelay
Specifies the delay in microseconds to apply after the
trigger reception before activating it. Possible values
are:
0 - 1*10^6µs
Beginner
LineSelector
LineSelector
Selects the logical line of the device to configure.(RW)
Beginner
General Purpose Input 1
Line1
General Purpose Input 1
General Purpose Input 2
Line2
General Purpose Input 2
General Purpose Output
1
Line3
General Purpose Output 1
General Purpose Output
2
Line4
General Purpose Output 2
Line Mode
LineMode
Returns if the selected physical pin is used as an input
or output signal. <RO>
Beginner
Input
Input
The selected physical pin is used as an input.
Output
Output
The selected physical pin is used as an output.
Line Pinout
linePinAssociation
Gets the physical pin location associated with the
logical line. The H1 prefix refers to the Hirose Power
and input cable (see Figure 6). <RO>
DFNC
Beginner
H1_Pin6Pos_Pin5Neg
H1_Pin6Pos_Pin5Neg
General Purpose Input 1:
Hirose Pin 6 Positive, Pin 5 Negative.
