Teledyne AutoInjector Module, Installation And Operation Manual

Page: 28 / 74

Automation
Section 3 The AutoSampler Module
3-6
Figure 3-9 Probe clamps inserted into the Z-axis slider
11. Insert the probe into the hole in the top of the Z-axis slider
and through the holes of the loosened probe clamps.
Figure 3-10 Probe inserted into the Z-axis slider
12. Move the Z-Drive to the topmost position on the Z-axis.
13. Guide the probe down until the tip of the probe is level
with the bottom of the Z-Drive, and then tighten the probe
clamps with your hands.
Mounting the AutoInjector
Module 14. Install the AutoInjector Module onto the AutoSampler
Module by removing the upper-left and lower-right mount-
ing screws on the AutoSampler Module back panel.