Teledyne Analytical Instruments LXT-380, Instructions Manual

Page: 51 / 104

Operation LXT-380 Universal Transmitter
Teledyne Analytical Instruments
32
•
“Save Changes?” press YES.
•
Choose Display Mode, DATA , mV or GRAF
by pressing selection Key. The selection key
displays which screen will be displayed next.
•
The type of graphical display used,
Line, Bar or Gauge is selected in
CONFIG → XMTR → LCD →
GRAPH → LINE, GAUGE, BAR.
3.3.5 SENSOR START UP
All sensors are supplied with protective caps over the sensing end.
Remove the cap(s) from the sensor before installing in the process. All
sensors were calibrated at the factory before shipment, no calibration
should be necessary before use.
Allow the sensor to equilibrate to the process solution conditions
for ½ hour before verifying the reading against a grab sample. If
calibration is required follow the instruction in Section 4.0 below.
3.4 USER SELECTABLE OPTIONS
3.4.1 SCREEN LIGHTING
LED back lighting is available on DC powered instruments only
and this feature is inactive on all loop powered instruments.
Contrast can be adjusted for optimal viewing. The Backlight can be
adjusted to timeout after a set period of time or remain on.
Location: CONFIG → XMTR → LCD → Set Up → CONT,
BACK LIGHT.
3.4.2 GRAPHICAL DISPLAY
There are three graphical display choices: