TCM260904
Rev
0.1
TCM260904
Page 14 of 31
C
HANGE OF
F
REQUENCY
This remote controller provides 3 operating frequencies. When remote controller is interfered by radio wave and can’t
operate properly, the operator can change the transmitter’s frequency according to the following procedures without
changing the channel in the receiver. This eliminates the trouble of climbing to the receiver.
Note 1: From the transmitter, one can depress the corresponding pushbutton to change operation frequency. In the meantime,
LED indicator displays different colours to show the operation frequency as follows:
Operation frequency
LED Colour
Corresponding pushbutton
Frequency A
Red
“Up” pushbutton
Frequency B
Yellow
“Down” pushbutton
Frequency C
Green
“East” pushbutton
Note 2: From the transmitter, one can follow to the below-mentioned procedures to check the operation frequency.
(1)
Press EMS mushroom.
(2)
Turn security key to “Off” position and then turn security key clockwise from “Off” to “On” position.
(3)
At this moment, LED indicator will display the corresponding colour to show the present operation frequency
of transmitter.
Note 3: Both receiver and transmitter must be in the same operation frequency to operate properly. (e.g. both in Frequency A,
or B, or C).
Note 4: Channels 1 to 256 can be set by Dip switch in the receiver or set by software.
A
1
A
2
……………… …..….A
256
B
1
B
2
…… ……. C
1
C
2
………………………. C
256
Dip switch in the receiver is an 8-bit for 256 channels. If current setting is channel 16, one can choose among frequency A16,
B16, C16.
˙Bandwidth of each section and separation between channels can be
set by software. e.g. A1=430,000MHz A2=430,025MHz…..
A255=436,375MHz; B1=436,400MHz…etc.
