TCM260904
Rev
0.1
TCM260904
Page 12 of 31
OPERATION
S
TART
U
P
Remove the cover of battery box.
(1)
Install 4 Fresh AA-size batteries in the battery box. Make sure the “+” and “-” directions are correct.
(2)
Attach back the battery cover.
Note: Transmitter will sound two-long beeps to indicate the correct installation.
(3)
Turn on the power according to the “Power-On Modes” (see below).
Note: LED indicator will flash with red colour if proper procedures are not followed.
(4)
Operate transmitter by pressing each pushbutton.
(5)
After operation, perform the following procedures in sequence: (1) Press EMS mushroom, (2) rotate key
counter-clock-wise to the “OFF” position, (3) remove key and keep it in a safe place, (4) remove batteries if
not used for a long period.
P
OWER INDICATING FUNCTIONS OF
LED
DISPLAY
.
Green:
Sufficient power to operate transmitter.
(In order to save power, one can program to turn off LED display when power is sufficient.)
Yellow:
Power is depleting, warning sound occurs every 4 seconds
(can be switched off and sound interval can be set by software).
Operation must be stopped immediately (for example: lower the goods to ground) to replace batteries.
Red:
Insufficient power.
In addition to red LED, warring sound will continue and transmitter will no longer function.
Transmitter will send out an emergency stop signal to the receiver due to insufficient power.
Operator should avoid this situation in order to maintain the safety of operation.
P
OWER
-O
N OPERATION
Power-on means that the Main-Relay on receiver will energize as soon as receiving the control data from transmitter and then
receiver keep in condition of standby for continuous control. There are 4 different ways of “Power-On mode” could be setting.
A
NY PUSHBUTTON
P
OWER
-O
N
M
ODE
(1)
Rotate “EMS” mushroom clockwise 45º and pull out.
(2)
Turn key clockwise to “ON” position.
(3)
Press any pushbutton on the transmitter (or A, B switch). This will turn on the power as well as execute the
function of pushbutton.
“S
TART
”
(M
AGNETIC
K
EY SWITCH
)
P
OWER
-O
N
M
ODE
(1)
Rotate “EMS” mushroom clockwise 45º and pull out.
(2)
Turn Key switch clockwise to “ON” position.
(3)
Turn Key switch 45º beyond “ON” position to turn on power.
Note: When setting is on “Any pushbutton power-on” or “Start pushbutton power-on”, the transmitter is in the “non-
continuous” mode (i.e. pushbutton must be pressed to operate the function), it can save power.
