English
TS6004
7
4.1.3 Password
To modify some important menu parameters or view programs protected by Parental Lock, the receiver
requires a PIN (a four number password). The factory set password is “
0000
” (four times zero), but it can be
personalised through the
Change password
option.
x
Setup Menu lock
If set to
ON
access to the main menu is protected by password.
x
Channel block
If set to
ON
, you can manually and individually block channels, using the
Block
option on the “
TV list
” or
“
Radio list
” menu.
x
Censorship Lock
The Parental Lock function allows for the viewing of sensitive material to be controlled. If a channel
transmits a program with view control aimed at a public of the same age or older than the age level
selected from the menu, the receiver will block the channel and a message will appear on the screen. To
see the program, the PIN must be entered. (see section 4.1.3).
The default age level is 18 years old. To modify the age level, use the / arrows.
x
Change password
Personalise password (PIN).
CAUTION!
Write down and save your new PIN in a secure place. If you forget it, use the universal code “
8888
” to access the
Password
menu and set a new password.
4.1.4 Advance Timer
To set the decoder’s on-off timer: press the red button, insert the data requested and press
OK
.
4.1.5 SW update
In order to improve or add new functions to the receiver, it may be necessary update the software. Keeping
the receiver updated is advised.
x
Via OTA (Over the Air)
The receiver can detect the software updating data from the digital terrestrial signal coming from the
antenna when the data is transmitted by a television station.
CAUTION!
Downloading and installing new software can require a lot of time especially with bad reception. During the process,
do not interact with the receiver or unplug the power cable: the receiver may be irreversibly blocked!
x
Manually
Access the “
SW Update
–
Update via OTA
” menu and press
OK
to start the manual search function to
update new software.
x
Automatically
Access the “
SW Update
–
Update via OTA
” menu to personalise the automatic search for software
updates. Two options will appear from the “
OTA in Operative Mode
”
parameter:
x
OFF
: when the new software control in operative mode is deactivated, a search in “
Standby Mode
”
(if activated) will start up 45 min. after going into standby.
x
ON
: by activating “
OTA in Operative mode
”, the receiver will control the time indicated in the
Time
field on a daily basis and with the frequency indicated in the “
OTA Frequency”
field. In this case, a
control in “
Standby Mode
“ (if active) will start only at the time displayed in the menu.
4.1.6 Factory reset
If necessary, reset the receiver to its factory settings through a software reset. Go to the
Set Default
menu
and press the
OK
button. You will be asked to confirm.
CAUTION!
Factory Reset means you will lose all the channels that were memorised and all personalised settings, but not the last
version of the software installed.
