ethernetX/X switch config>list ?
configuration
Lists ports configuration
stp
Lists the Spanning Tree Protocol configuration
7.6.6.1 LIST CONFIGURATION
Displays the configuration of the various switch ports.
Syntax:
ethernetX/X switch config>list configuration
Example:
ethernet3/0 switch config>list configuration
Auto-negotiation Advertise
Storm Control
Port
Ena
Aneg
Speed
Duplex
FC
100FD 100HD 10FD 10HD FlowC
Packets
Lvl
----
---
----
-----
------ ---- --------------------------- --------------- ---
1
Y
Y
100
Half
N
Y
Y
Y
Y
Y
Bcst
15
2
Y
Y
100
Half
N
Y
Y
Y
Y
Y
Disabled
15
3
Y
Y
100
Half
N
Y
Y
Y
Y
Y
Disabled
15
4
Y
Y
100
Half
N
Y
Y
Y
Y
Y
Disabled
15
ethernet3/0 switch config>
The meaning of the columns is as follows:
Port:
Switch port identifier.
Ena (Enable)
: Indicates whether the port is enabled or not. If the port is disabled, data is not transmitted or received
through it.
Aneg (Auto-negotiation)
: Indicates if auto-negotiation is enabled or not. Whenever it is enabled, the rate and duplex
mode for the port are set (based on the characteristics of the devices connected to the network segment where the
port is connected).
Speed
: Speed in Mbps configured for the port. This is only valid when auto-negotiation is disabled.
Duplex
: Duplex mode configured for the port. This is only valid when auto-negotiation is disabled.
FC
: Flow control (Pause) configured for the port. This value is only used if auto-negotiation is disabled.
Auto-negotiation Advertise
: Indicates the characteristics the port advertises to other devices connected to the same
segment during auto-negotiation. The configurable characteristics are as follows:
• 100FD: the device is capable of operating at 100Mbps, Full-Duplex.
• 100HD: the device is capable of operating at 100Mbps, Half-Duplex.
• 10FD: the device is capable of operating at 10Mbps, Full-Duplex.
• 10HD: the device is capable of operating at 10Mbps, Half-Duplex.
• FlowC: the device understands flow control commands.
Storm control
: traffic storm control configuration per port. The configurable characteristics are as follows:
• Packets: type of packets calculated when determining if the traffic control should be activated in a port.
• Lvl (Level): percentage of bandwidth that must be surpassed for traffic control to activate.
7.6.6.2 LIST STP
Displays the global configuration for a Spanning Tree protocol instance.
Syntax:
ethernetX/X switch config>list stp <instance>
<instance> Spanning Tree instance identifier. You can configure up to 16 Spanning Tree instances in a switch.
Example:
ethernet1/0 switch config>list stp 1
STP instance
1
---------------
Address:
00-a0-26-21-22-41
Priority:
32768
Teldat SA
7 Switch Configuration
LAN Interfaces
47
