REPEATER-SWITCH
Accesses the switch monitoring menu.
STATUS
Displays the status of the Ethernet interface.
SUBIFCS
Displays information on the Ethernet subinterfaces configured over the Ethernet
interface.
EXIT
Exits the Ethernet monitoring menu.
4.3.1 ? (HELP)
Shows the available commands or their options.
Syntax:
ethernetX/X ETH>?
Example:
ethernet0/0 ETH+?
bitrate
Bit rate monitor
collision
List collisions statistics
counters
List device counters
dot1x
Access to 802.1X monitoring
laser
List laser parameters
llc
Access to llc monitoring
oam
Ethernet OAM monitoring
power-sourcing-equipment
Access to power source engine monitoring
registers
List device registers
repeater-switch
Access to switch monitoring
status
List interface status
subifcs
List ethernet subinterfaces info
exit
ethernet0/0 ETH+
Command history:
Release
Modification
11.01.03
The "Subfics" command was introduced as of version 11.01.03.
4.3.2 BITRATE
Measures the real transmission and reception rate in the Ethernet line. The rate is measured in intervals of 1 second
for bits per second (bps) and for packets per second (pps). A new line is created every time the rate exceeds a max-
imum historic value at the point where the command was executed. Press any key to finalize rate monitoring.
Syntax:
ethernet
X/X
ETH+bitrate
Example:
ethernet0/0 ETH+bitrate
Interface ethernet0/0
Trx rate (bps/pps)
Rcv rate (bps/pps)
--------------------------------------
0/
0
2000/
3
0/
0
8000/
5
0/
0
8000/
13
0/
0
4000/
5
ethernet0/0 ETH+
4.3.3 COLLISION
Displays the counters for frames that suffered from collisions before being successfully transmitted. The counters
tally the number of frames that were successfully sent after a specified number of collisions (ranging from 1 to 16).
An increase in the number of frames transmitted with collisions and in the number of collisions per frame indicates a
busy Ethernet line.
4 Monitoring Ethernet Interfaces
Teldat SA
20
LAN Interfaces
