Access Control Config> refresh-mac-interval ?
<1..65535>
Value in the specified range
Example:
Configuring 600 seconds as a refresh interval.
Access Control Config> refresh-mac-interval 600
7.6.3 AGING-TIME
Configures the aging time for MAC addresses learned by the switch.
Syntax:
ethernetX/X switch config>aging-time <value>
<value> Value between 1 and 3600 seconds.
Example:
ethernet1/0 switch config>aging-time 60
NO configures the aging default value (300 seconds).
7.6.4 CPU
Configures CPU port options.
Syntax:
ethernetX/X switch config>cpu
flow-control Configures flow control mode
disabled
Disables flow control mode
enabled
Enables flow control mode
rx-only
Enable asymmetric PAUSE toward local device
tx-only
Enable asymmetric PAUSE toward link partner
Note
This command is not available on all platforms.
Command history:
Release
Modification
11.01.05
This command was introduced as of version 11.01.05.
7.6.5 DOWN-BY-DEFAULT
When configuring the down-by-default command, the interface status will be down if there is nothing connected to it.
Otherwise, the interface base will always be up.
It is important to keep in mind that raising an interface could take a while.
Example:
ethernet0/0 switch config>down-by-default
Command history:
Release
Modification
11.01.04
The "Down-by-default" command was introduced as of version 11.01.04.
7.6.6 LIST
Displays the switch configuration.
Syntax:
7 Switch Configuration
Teldat SA
46
LAN Interfaces
