TelcoBridges 800 1+1 series, Installation Manual

Page: 28 / 58

800 Series Standalone and 800 Series 1+1 System Installation Guide
22
2.5.1 Connecting to the 800 Series 1+1 System Management Interfaces
The 800 series gateway provides redundant management interfaces enabling administrators to perform
management tasks an the 800 series 1+1 system.
Prerequisites
To communicate with the management interface, the following is needed:
• Two or four CAT5 Ethernet cables with RJ45 male-male terminations.
Interconnections
An 800 series 1+1 system provides redundant management interfaces for an 800 series and an 800 +1
gateway, each using a gigabit Ethernet network link. See
figure 2.8 on page 22.
To communicate with the management interface:
1. Connect a CAT5 Ethernet cable to the port labeled “”MGMT0” at the rear of the 800 series gateway
to the first gigabit Ethernet switch.
2. If your system employs a second Gigabit Ethernet switch for redundancy, connect a second CAT5
Ethernet cable to MGMT1 at the rear of the 800 series gateway. Connect the other end of the same
CAT5 cable to a second gigabit Ethernet switch.
3. Repeat steps 1 and 2 for the 800 1 unit.
Figure 2.8 Management Interface
Note
The default IP addresses for the management ports are located in the “Important Notice”
sheet received with the shipment. MGMT ports are configured in bonding.
If you do not know the default IP address, go to Section 3.6 “Changing the 800 Series
Gateway Management Port IP Address” on page 45.
Gi g abit
Ethernet
Switch 1
Gi g abit
Ethernet
Switch 2
Mana g ement Interface 2
Mana g ement Interface 1
800 Series Unit
800 1 Unit
15 14 13 12
10 11 8 9 3 2 0
7 6 5 4
1
MGMT0
MGMT1
ETH0
ETH1
VOIP0
VOIP1
15 14 13 12
10 11 8 9 3 2 0
7 6 5 4
1
MGMT0
MGMT1
ETH0
ETH1
VOIP0
VOIP1
Mana g ement Interface 1
Mana g ement Interface 2