TelcoBridges 800 1+1 series, Installation Manual

Page: 50 / 58

800 Series Standalone and 800 Series 1+1 System Installation Guide
44
3.3 Configuring the Terminal Emulator Application
Before communicating with the management interface, you must first configure a terminal emulator or
console application to communicate with the 800 series system in order to configure initial settings.
Available terminal emulation software includes:
• HyperTerminal
• Putty
• Minicom
To configure the terminal emulator application:
1. Set the baud rate (bits per second) to 9600
2. Set the data rate to 8 bits
3. Set the parity to None
4. Set the stop bits to 1
5. Set the flow control to None
Note
See Section 3.6 on page 45 to learn how to change the IP address of the MGMT0 port.
3.4 Connecting to the 800 Series Gateway
The 800 series gateway is shipped with the TMG-CONTROL software preinstalled. In order to make
changes to the system configuration, you must connect the port labeled MGMT0 at the rear of the 800
series gateway to a terminal.
To access the 800 series gateway, you must use an SSH connection. The password is set at the factory
and is indicated on the shipment sheet.
Figure 3.4 800 Series Gateway Management Interface
Mana g ement Interface
15 14 13 12
10 11 8 9 3 2 0
7 6 5 4
1
MGMT0
MGMT0
ETH0
ETH0
VOIP0
VOIP1