Tektronix TMS 440 SH-3 7708, Instruction Manual

Page: 18 / 100

Getting Started
1–2
TMS 440 SH-3 7708 Microprocessor Support
Logic Analyzer Software Compatibility
The floppy disk label on the microprocessor support states which version of logic
analyzer software this support is compatible with.
Logic Analyzer Configuration
To use the SH-3 7708 support, the TLA 700 Series logic analyzer must be
equipped with a 102-channel module at a minimum. The module must be
equipped with enough probes to acquire channel and clock data from signals in
your SH-3 7708-based system.
Refer to information on basic operations to determine how many modules and
probes the logic analyzer needs to meet the channel requirements.
For the TLA 700 Series logic analyzer, the TMS 440 channel assignments follow
the standard channel mapping and labeling scheme for P6434 probes. Follow the
procedure to apply labels, using the standard method as described in the P6434
Mass Termination Probe Instructions.
Requirements and Restrictions
You should review the general requirements and restrictions of microprocessor
support packages in the information on basic operations as they pertain to your
SUT.
You should also review electrical, environmental, and mechanical specifications
in Specifications in this manual as they pertain to your system under test, as well
as the following descriptions of other SH-3 7708 support requirements and
restrictions.
System Clock Rate. The SH-3 7708 microprocessor support can acquire data from
the SH-3 7708 microprocessor operating at tested speeds of up to 60 MHz. This
specification is valid at the time this manual was printed. Please contact your
Tektronix Sales Representative for current information on the fastest devices
supported.