Tektronix TMS 440 SH-3 7708, Instruction Manual

Page: 13 / 100

TMS 440 SH-3 7708 Microprocessor Support
ix
Preface
This instruction manual contains specific information about the TMS 440
SH-3 7708 microprocessor support package and is part of a set of information on
how to operate this product on compatible Tektronix logic analyzers.
If you are familiar with operating microprocessor support packages on the logic
analyzer for which the TMS 440 SH-3 7708 support was purchased, you will
only need this instruction manual to set up and run the support.
If you are not familiar with operating microprocessor support packages, you will
need to supplement this instruction manual with information on basic operations
to set up and run the support.
Information on basic operations of microprocessor support packages is included
with each product. Each logic analyzer includes basic information that describes
how to perform tasks common to support packages on that platform. This
information can be in the form of online help, an installation manual, or a user
manual.
This manual provides detailed information on the following topics:
H
Connecting the logic analyzer to the system under test
H
Setting up the support to acquire data from the system under test
H
Acquiring and viewing disassembled data
Manual Conventions
This manual uses the following conventions:
H
The term “disassembler” refers to the software that disassembles bus cycles
into instruction mnemonics and cycle types.
H
The phrase “information on basic operations” refers to online help, an
installation manual, or a user manual covering the basic operations of
microprocessor supports.
H
In the information on basic operations, the term “XXX” or “P54C” appearing
in field selections and file names must be replaced with SH-3. This term is
the name of the microprocessor in field selections and file names you must
use to operate the SH-3 7708 support.
H
The term “SUT” (system under test) refers to the microprocessor-based
system from which data will be acquired.