Benchtop Controller Removal and Installation Procedures
6- 36
TLA721 Benchtop & TLA7XM Expansion Mainframe Service Manual
CD-ROM Drive
You must remove the hard disk drive interface board so that you can access the
CD-ROM drive. You will need a screwdriver with a T-10 Torx tip and a #0
Phillips head screwdriver to remove the CD-ROM drive.
The CD-ROM drive is located on the hard drive interface board. Complete the
following steps to remove the CD-ROM drive:
1.
Remove the left and rear covers by completing the
Cover Removal
proce-
dures on page 6--29.
2.
Remove the injector handles by completing the procedure on page 6--28.
3.
Remove the front panel and the hard disk drive interface board by following
the procedure beginning on page 6--30.
4.
Remove the six T-10 screws on the bottom of the hard disk drive interface
board that secure the CD-ROM drive bracket (see Figure 6--21).
5.
Remove the CD-ROM drive bracket from the hard disk drive interface board.
6.
Using a #0 Phillips head screwdriver with, remove the four screws on the
sides of the CD-ROM bracket (see Figure 6--21).
7.
Remove the ribbon cable from the CD-ROM drive.
8.
Remove the CD-ROM drive assembly from the bracket.
9.
Disconnect the interface board from the CD-ROM drive.
To install the CD-ROM, complete the following steps:
1.
Connect the interface board to the CD-ROM drive.
2.
Install the CD-ROM drive assembly in the bracket using the four screws that
you removed earlier. Tighten the screws to 1 in-lbs.
3.
Install the CD-ROM drive assembly to the hard disk drive interface board by
attaching the six T-10 screws on the bottom of the board; tighten the screws
to 3 in-lbs.
4.
Connect the CD-ROM drive ribbon cable to the CD-ROM drive. Verify that
pin-1 of the cable is connected to pin-1 of the connector.
5.
Install the hard disk drive interface board and the front panel.
6.
Install the covers and the injector handles.
Removal
Installation
Summary of Contents for TLA7XM
