Tektronix TLA600 Series, Service Manual

Page: 54 / 188

Performance Verification: Logic Analyzer
TLA600 Series Logic Analyzer Service Manual
4- 3
Test Equipment
The procedures use external, traceable signal sources to directly test characteris-
tics that are designated as checked (
n
) in the Specifications chapter of this
manual. Table 4--1 shows the required equipment list; the equipment is required
for the performance verification procedures and adjustment procedures for the
logic analyzer modules and for the adjustment/verification fixture.
Table 4- 1: Test equipment
Item number and description Minimum requirements Example
1. Mainframe TLA600 Series Logic Analyzer --
2. Adjustment/verification fixture,
with one of the following
Power Supplies:
USA/CAN
Europe
Japan
United Kingdom
12 V, 1.5 A
12 V, 1.5 A
12 V, 1.5 A
12 V, 1.5 A
Tektronix part number 671-3599-XX
Tektronix part numbers:
119-4855-XX
119-4856-XX
119-4859-XX
119-4857-XX
3. Oscilloscope 1 GHz bandwidth Delay time accuracy
±
25
ppm over any
≥
1 ms interval
Tektronix TDS 784D
4. DSO probes Two required, with < one-inch ground leads Tektronix P6243 or P6245 probe, with accesso-
ries
5. 1X probe One required, with < one-inch ground leads Tektronix P6101B probe, with accessories
6. Logic analyzer probes Two required Tektronix P6417 or P6418 Logic Analyzer probes
7. High density logic analyzer
probe (optional)
One required Tektronix P6434 Logic Analyzer probe
8. Frequency counter Frequency range: 1 GHz Tektronix DC508
9. Digital multimeter with leads DCV accuracy: 0.1% from --10 V to +100 V Tektronix DMM 900 Series
10. Connector, dual-banana Female BNC-to-dual banana Tektronix part number 103-0090-XX
11. Voltage reference Accuracy:
≤
0.01% Data Precision 8200
12. Capacitor
1
0.1 F, 200 V Tektronix part number 283-0189-XX
13. Adapter, N-to-BNC Male type N-to-female BNC Tektronix part number 103-0045-XX
14. Shorting jumpers Strip of 10, 2-wide Tektronix part number 131-5829-XX
15. Cable, precision 50
Ω
coaxial 50
Ω
, 36 in, male-to-male BNC connectors Tektronix part number 012-0482-XX
16. Signal Generator 250 MHz Tektronix SG503
1
The capacitor is installed across the Data Precision 8200 output terminals to reduce noise. If your voltage reference
produces <4 mVp-p of noise, external noise reduction is not necessary.