Tektronix TLA600 Series, Service Manual, Page: 92 / 188

TLA600 Adjustment Procedures
TLA600 Series Logic Analyzer Service Manual
5- 3
Adjustment Instructions
This section describes how to perform adjustments using the performance
verification and adjustment software.
The performance verification and adjustment software contains instructions for
performing the adjustments. The basic steps for completing the procedures
follow:
1. Start the program, enter user and product identification information and
temperature and humidity.
2. If you are using P6417 or P6418 probes, label one probe as the Reference
Probe, and the other probe as the Probe Under Test.
3. If you are using a P6434 probe, label the probe channel group identified as
the pin 38 side as Probe A. Label the probe channel group identified as the
pin 1 side as Probe B, refer to Figure 5--1.
Pin 1 side
Pin 38 side
Recess on
pin 1 side
Pin 1 label
End view
Pin 38 side
Beveled corners
Beveled corners
Figure 5- 1: P6434 probe detail
4. Select a full adjustment sequence.
5.
Connect the test equipment.
Using the PV/Adjust
Software