Tektronix TLA600 Series, Service Manual

Page: 145 / 188

Removal and Installation Procedures
6- 36
TLA600 Series Logic Analyzer Service Manual
Replacing the Acquisition Board
To replace the acquisition board, follow these instructions:
1. Remove the trim and covers by following the procedure on page 6--7.
2. Remove the front and rear power distribution boards.
3. Disconnect the P200, I-A bus board
4. Place the instrument so its top is down on the work surface and the bottom is
facing you.
5. Remove the seven T-15 Torxdrive screws that secure the acquisition board to
the bottom chassis.
6. Remove the six T-15 Torxdrive screws that secure the acquisition board to
the front chassis.
7. Remove the old acquisition board.
8. Install the new acquisition board using seven T-15 Torxdrive screws to
secure the acquisition board to the bottom chassis.
9. Install the six T-15 Torxdrive screws to secure the acquisition board to the
front chassis.
10. Install the front and rear power distribution boards, and the P200, I-A board.
11. Install the covers and trim following the procedures that start on page 6--6.
12. Verify the operation by following the procedure on page 6--40.