Expansion Chassis Specifications
1–12
TLA 720 Benchtop Chassis and TLA 7XM Expansion Chassis Service Manual
Table 1–10: Certifications and compliances (Cont.)
Category
Standards or description
U.S. Nationally Recognized Testing
Laboratory Listing
UL3111-1
Standard for electrical measuring and test equipment.
Canadian Certification
CAN/CSA C22.2 No. 1010.1 Safety requirements for electrical equipment for measurement,
control, and laboratory use.
Installation (Overvoltage) Category
Terminals on this product may have different installation (overvoltage) category designations.
The installation categories are:
CAT III
Distribution-level mains (usually permanently connected). Equipment at this level is
typically in a fixed industrial location.
CAT II
Local-level mains (wall sockets). Equipment at this level includes appliances, portable
tools, and similar products. Equipment is usually cord-connected.
CAT I
Secondary (signal level) or battery operated circuits of electronic equipment.
Pollution Degree
A measure of the contaminates that could occur in the environment around and within a
product. Typically the internal environment inside a product is considered to be the same as the
external. Products should be used only in the environment for which they are rated.
Pollution Degree 2
Normally only dry, nonconductive pollution occurs. Occasionally a
temporary conductivity that is caused by condensation must be
expected. This location is a typical office/home environment.
Temporary condensation occurs only when the product is out of
service.
Safety Certification Compliance
Altitude (maximum operating)
2000 meters
Equipment Type
Test and measuring
Safety Class
Class 1 (as defined in IEC 1010-1, Annex H) – grounded product
Pollution Degree
Pollution Degree 2 (as defined in IEC 1010-1). Note: Rated for indoor use only.
Table 1–11: Environmental
Characteristic
Description
Classification
Atmospherics
Temperature
Operating
+5
°
C to 50
°
C, 15
°
C/hr max gradient, non-condensing (derated 1
°
C per 1000 ft. above
5000 ft. altitude
Nonoperating
–20
°
C to 60
°
C, 15
°
C/hr max gradient, non-condensing
Relative Humidity
Operating
20% to 80% relative humidity, non-condensing.
Max wet bulb temperature: +29
°
C
(derates relative humidity to approximately 22% @ 50
°
C).
Summary of Contents for TLA 720
