Tektronix TDS5032, Manual

Page: 53 / 248

Operating Basics
6. Select the channel source in the D+ and D– fields. Use the drop down arrow
in the D+, D- field to set the source. The available options are: Ch1- Ch4
and Ref1-Ref4.
7. Select the Run button.
8. To generate reports, select Utilities> Report Generator.
Configuring Reset from High Speed Measurement
To configure Reset from High Speed measurement, follow these steps:
1. Select the High Speed measurement tab> More button> Reset from High
Speed measurement. This is the time between the beginning of the last SOF
and before the reset and the beginning of Chirp-K. This test will be
applicable for Device and HUB upstream.
2. To access the Configure Measurements menu, go to Measurements>
Configure.
Figure 18: Configuring Reset from High Speed measurement
3. The Upstream signal direction is enabled by default. This is because you can
measure Reset from High Speed only on an upstream signal. The
Downstream option is disabled here.
4. Select the channel source in the D+ and D– fields. Use the drop down arrow
in the D+, D– field to set the source. The available options are: Ch1- Ch4
and Ref1-Ref4.
5. Select the Run button.
6. To generate reports, select Utilities> Report Generator.
TDSUSB2 Universal Serial Bus Measurement Package 39