Tektronix TDS5032, Manual

Page: 185 / 248

Reference
Table 36.Error Code descriptions (cont.)
Save and Recall
E751 The file name has invalid
characters and could not be
saved
The application expects the file
names in alphanumeric characters Make sure the valid characters are used in
the file names
E754 The file name has invalid
characters and could not be
recalled
The application expects the file
names in alphanumeric characters
Make sure that valid characters are used in
the file names
E752 The file does not exist The file name selected for recall
does not exist Recall an existing file name
E753 The saved file has been
corrupted and not recalled
The application saves the
application settings with the .ini file
extension. The user should not
modify the data inside the file
Try recalling a correct file. Store the settings
to a new file and recall it when needed
Save and Recall
E801 The current signal is not a Chirp
Signal. Acquire the correct
signal and proceed
The acquired signal is not a correct
Chirp Signal. Correct Chirp Signal is
required to perform chirp
measurements
Try acquiring the signals again by pressing
Run button
E802 No Chirp-K or Chirp-J state
found
As part of the USB2.0 Chirp
description, a minimum of 1 Chirp-K
and 1 Chirp-J state are expected
after Chirp Response timing
calculation
Press the Run button to acquire the signals
E803 There should be at least 3
Chirp-K and 3 Chirp-J state
As part of the USB2.0 Chirp
description, a minimum of three
Chirp-K and three Chirp-J state are
expected after Chirp Response
timing .An absence of this may lead
to incorrect results
Press the Run button to acquire the signals
E-804 No Chirp-J state found As part of the USB2.0 Chirp
description, a minimum of one
Chirp-J state is expected after Chirp
Response timing. An absence of this
may lead to incorrect results
Press the Run button to acquire the signals
E-805 No Chirp-K state found As part of the USB2.0 Chirp
description, a minimum of one
Chirp-K state is expected after Chirp
Response timing. An absence of this
may lead to incorrect results
Press the Run button to acquire the signals
TDSUSB2 Universal Serial Bus Measurement Package 171