Tektronix TDS 510A, Instruction Manual, Page: 70 / 116

Performance Tests
1–56
TDS 510A Performance Verification and Specifications
Press the main-menu button Source.
Press the side-menu button Ch3.
Set vertical SCALE to 100 mV.
Press SET LEVEL TO 50%.
Press MEASURE; then press the main-menu button Select
Measrmnt for Ch2.
Repeatedly press the side-menu button –more– until Pk-Pk appears
in the side menu (its icon is shown at the left). Press the side-menu
button Pk-Pk.
Press CLEAR MENU.
b. Check against limits:
CHECK that the readout Ch2 Pk-Pk is between 90 mV and 110 mV,
inclusive.
Enter voltage on test record.
Press VERTICAL MENU; then press the side-menu button to
toggle to the 50
W
setting.
Press CLEAR MENU.
CHECK that the readout Ch2 Pk-Pk is between 45 mV and 55 mV,
inclusive.
Enter the voltage on the test record.
4. Disconnect the hookup: Disconnect the cables from the channel inputs and
the rear panel outputs.
Equipment
Required One female BNC to clip adapter (Item 3)
Two dual-banana connectors (Item 6)
One BNC T connector (Item 7)
Two 50 precision cables (Item 5)
One DC calibration generator (Item 9)
Prerequisites See page 1–15. Also, the oscilloscope must have passed Check
Accuracy For Long-Term Sample Rate and Delay Time Measurements
on page 1–38.
Check Probe
Compensator Output