Tektronix TDS 510A, Instruction Manual, Page: 28 / 116

Brief Procedures
1–14
TDS 510A Performance Verification and Specifications
For example, the first time you run this on a blank, formatted disk or
on the Example Programs Disk, the oscilloscope will assign the
name
to your file. If you ran the procedure again, the
oscilloscope would increment the name and call the file
.
Press the side-menu button Save To Selected File.
2. Verify the file system works:
Press the main-menu button Recall Factory Setup and the side-menu
button OK Confirm Factory Init to restore the 500
m
s time base and
the five cycle waveform.
Press the main-menu button Recall Saved Setup; then press the
side-menu button From File.
Turn the general purpose knob to select the file to recall. For example, if
you followed the instructions above and used a blank disk, you had the
oscilloscope assign the name TEK00000.SET to your file.
Press the side-menu button Recall From Selected File.
Verify that oscilloscope retrieved the saved setup from the disk. Do this
by noticing the horizontal SCALE for the M (main) time base is again
200
m
s and the waveform shows only two cycles just as it was when you
saved the setup.
3. Remove the test hookup:
Disconnect the probe from the channel input and the probe-compensa-
tion terminals.
Remove the disk from the disk drive. Do this by pushing in the tab of
the disk drive.