Installation
RFA300A Measurement Set 8VSB
1- 9
3.
Mount the stationary sections (with extension brackets attached) to the front
and rear rails of the equipment rack.
a.
Install the rear of the stationary section in front of, behind, or beside the
rear rail of the equipment rack. Use the mounting holes in the rear rails
that correspond to the same level as the front rail holes selected.
If the rear-rail mounting holes are tapped, the bar nut is not used to
attach the extensions. If the rear-rail mounting holes are not tapped, use
the bar nut on the inside of the rail, as shown in Figure 1--5A or use
suitable captive nut clips (not supplied). Figure 1--5B shows the
extension bracket mounted to the inside surface of the rear rail.
Rear rail
Bar nut (use
if rear rail is
not tapped)
10-32 PNH
screws
Rear rail
Method A
Method B
Figure 1- 5: Attaching the extension bracket to the rear rail of the equipment rack
Summary of Contents for RFA300A
