Tektronix P6205, Instruction Manual

Page: 63 / 74

Maintenance
P6205 Instruction Manual
5–5
Figure 5–1: Disassembling the P6205 probe
Probe Resassembly. Refer to Figure 5–1 and use the following
procedure to reassemble the P6205 probe.
1. Verify that the center conductor of the probe cable is straight and
centered in its connector; the center conductor must align with a
receptacle seated deeply within the BNC and circuit board carrier
assembly.
2. Insert the probe cable into the receptacle in the center of the BNC
and circuit board carrier until it is fully seated. After inserting the
cable, handle the assembly carefully to minimize strain on the
BNC and cable assembly.
3. Taking care to minimize cable flex, insert the cable boot and
circuit board carrier into their respective slots in the compensa-
tion box bottom cover.
4. Resolder the red and black wires to their respective connections
on the circuit board. Resolder the uninsulated ground wire to its
connection on the circuit board.
5. Position the red and black wires so they will not be pinched when
you attach the compensation box top cover.