Tektronix P6205, Instruction Manual

Page: 45 / 74

Performance Verification
P6205 Instruction Manual
4–3
Oscilloscope settings (Cont.)
Control Setting
Trigger source Internal clock
Trigger mode Auto
Coupling DC
Waveform averaging On
Number of waveforms to average 8
Cursor type Horizontal bars
Cursor knob resolution Fine
2. Install one SMA-to-BNC adapter on an SD-24 sampling head
input channel and another adapter on the oscilloscope calibrator
output. Use the 10-inch coaxial cable to connect the oscilloscope
calibrator output to the SD-24 input channel. See Figure 4–1
below.
11801B oscilloscope
Figure 4–1: Attenuation test setup part 1
3. Press SELECT CHANNEL on the sampling head to enable the
corresponding input channel.
4. Adjust the oscilloscope controls as necessary to display a
waveform similar to the one shown in Figure 4–2 below.