Section 3: Setting up SMUs in Clarius
Model 4200A-SCS Source-Measure Unit (SMU) User's Manual
3-4
4200A-SMU-900-01 Rev. A December 2020
The connections selected in the Clarius software must accurately reflect the physical
hardware connections when the test is executed. Incorrect terminal configurations can result
in anomalous test results and device damage.
The key parameters for each terminal are displayed near the terminal. The key parameters include:
•
The type of terminal, such as gate, drain, source, or collector.
•
The instrument that is attached to the terminal. You assign the instrument, ground unit, or open
circuit that is physically connected to the terminal during the test.
•
The operation mode and basic settings for that mode. For example, the start and stop values are
displayed if a sweep operation mode is selected.
Figure 30: Configure pane
For user test modules (UTMs), the display depends on the settings of the user module that the UTM
is based on.
